Akw M11 DigiPump Instructies voor installatie en onderhoud - Pagina 3

Blader online of download pdf Instructies voor installatie en onderhoud voor {categorie_naam} Akw M11 DigiPump. Akw M11 DigiPump 20 pagina's.

Important Safety/Electrical Information

THIS CLASS II APPLIANCE DOES NOT REQUIRE AN EARTH

Caution Danger of Death 230V AC

Lethal Voltage present on the AC supply.

Ensure Mains Power Supply is Switched OFF before starting wiring.

DO NOT take risks with Plumbing or Electrical Installation. This product

must be installed and serviced by a competent and qualified person eg.

NIC EIC trades person should attempt this electrical installation in

accordance with the current edition of the Wiring Regulations (BS7671),

local by-laws and the current Building Regulations.

This product must be installed, used and maintained in good working

order in accordance with these instructions and recommendations.

If the supply cord is damaged, it must be replaced by the manufacturer

in order to avoid hazard.

The 230V AC power supply to this unit must be provided via a two-pole isolator

switch and a dedicated circuit with a 30mA RCD device installed in accordance

with the latest revision of the IEE Wiring Regulations BS7671. It must be wired into

a fused, unswitched, fixed wiring connector fitted with a 5 amp fuse.

The IP45 rating of the AKW pump product refers to the inner casing containing the

SELV electrical control gear. The pump motor which operates at SELV and is

located within the outer cover.

Before you start...

Standard JG pipe connectors ARE NOT SUITABLE for connecting to

CHROME or STAINLESS PIPEWORK.

Chrome plating must be completely removed 20mm before JG fittings are

connected to pipework.

Always use Collet Clips provided to ensure maximum grip.

It is not possible to connect JS fittings to Stainless Steel Pipe.

Confirm you have the required tools and parts.