Akw M11 DigiPump Інструкція з монтажу та догляду за користувачем - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу та догляду за користувачем для Сантехнічний виріб Akw M11 DigiPump. Akw M11 DigiPump 20 сторінок.
Друкувати сторінку
Important Safety/Electrical Information
THIS CLASS II APPLIANCE DOES NOT REQUIRE AN EARTH
Caution Danger of Death 230V AC
Lethal Voltage present on the AC supply.
Ensure Mains Power Supply is Switched OFF before starting wiring.
DO NOT take risks with Plumbing or Electrical Installation. This product
must be installed and serviced by a competent and qualified person eg.
NIC EIC trades person should attempt this electrical installation in
accordance with the current edition of the Wiring Regulations (BS7671),
local by-laws and the current Building Regulations.
This product must be installed, used and maintained in good working
order in accordance with these instructions and recommendations.
If the supply cord is damaged, it must be replaced by the manufacturer
in order to avoid hazard.
The 230V AC power supply to this unit must be provided via a two-pole isolator
switch and a dedicated circuit with a 30mA RCD device installed in accordance
with the latest revision of the IEE Wiring Regulations BS7671. It must be wired into
a fused, unswitched, fixed wiring connector fitted with a 5 amp fuse.
The IP45 rating of the AKW pump product refers to the inner casing containing the
SELV electrical control gear. The pump motor which operates at SELV and is
located within the outer cover.
Before you start...
Standard JG pipe connectors ARE NOT SUITABLE for connecting to
CHROME or STAINLESS PIPEWORK.
Chrome plating must be completely removed 20mm before JG fittings are
connected to pipework.
Always use Collet Clips provided to ensure maximum grip.
It is not possible to connect JS fittings to Stainless Steel Pipe.
Confirm you have the required tools and parts.
3