Boumatic Opti-Flo II Handleiding voor installatie-instructies - Pagina 4

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Boumatic Opti-Flo II. Boumatic Opti-Flo II 13 pagina's. Upgrade kit

Pagina afdrukken

not be running. Switch the Milk/Wash switch to the Wash

position and raise the low float. The motor should run up

to 60 Hz in just a few seconds. Lower the float switch and

the motor should stop turning in just a few seconds.

9. Adjust the parameters as required. All parameter defaults

are set for a 1 Hp motor. If a 2 Hp or 3 Hp motor is used,

some parameters must be changed. A listing of installation

specific parameters is given in Table 4. A complete

parameter list is given in Table A1-1.

10. If the individual components of the system seem to be

operating correctly, run a wash cycle to check out the

complete system. During the wash cycle, switch the Milk/

Wash mode between Milk and Wash modes. In the Wash

mode the control tries to run the milk pump at 60 Hz as long

as the low float switch is closed.

The pump will slow down quickly when the low float switch

opens. In the Milk mode the control tries to run the milk

pump at 50 Hz when the low float switch is closed, and will

ramp up to 60 Hz only when the high float switch closes.

Opti-FloII Upgrade Kit

It will ramp slowly down from 60 Hz only when the

high float switch opens. It will ramp slowly down

from the 50 Hz when the low float switch opens. If

the control is connected to a solenoid to control

water flow to a plate cooler, the solenoid should be

"OFF" when the control is in the Wash mode and the

solenoid should be "ON" when the control is in the

Milk mode, with the milk pump running.

11. Replace the existing wiring label with the wiring label

provided in the kit.

12. Mount the plastic shroud back onto the Magnetek

GPD 315.

13. Mount the access panel back onto the Magnetek

GPD 315.

14. Close and tighten the Opti-Flo II cover.

93-832