AnyCubic Kobra Handmatig - Pagina 4
Blader online of download pdf Handmatig voor {categorie_naam} AnyCubic Kobra. AnyCubic Kobra 10 pagina's.
Ook voor AnyCubic Kobra: Gebruikershandleiding (13 pagina's)
Pagina afdrukken
Warnings:
The module may only be operated at the voltage specified for it.
•
For devices with an operating voltage ≥ 35 volts, the final assembly may only be carried
•
out by a specialist in compliance with the VDE regulations.
The operating position of the device is arbitrary.
•
The permissible ambient temperature (room temperature) must not fall below or exceed
•
10°C and 70°C during operation.
The device is intended for use in dry and clean rooms.
•
If condensation forms, wait for an acclimatization period of up to 2 hours.
•
Operation of the device outdoors or in damp rooms is not permitted!
•
The device must be kept away from flower vases, bathtubs, washstands and all liquids.
•
Protect this board from moisture, splash water and heat!
•
The device must not be used in connection with easily flammable and combustible liquids!
•
Assemblies and components do not belong in children's hands!
•
The assemblies may only be put into operation under the supervision of a competent adult
•
or a specialist!
In commercial facilities, the accident prevention regulations of the German Federation of
•
Institutions for Statutory Accident Insurance and Prevention (Verband der gewerblichen
Berufsgenossenschaften) for electrical systems and equipment must be observed.
In schools, training facilities, hobby and do-it-yourself workshops, the operation of
•
assemblies must be responsibly supervised by trained personnel.
Do not operate the module in an environment where flammable gases, vapors or dusts are
•
present or may be present.
If the device ever needs to be repaired, only original spare parts may be used! The use of
•
deviating spare parts can lead to serious damage to property and personal injury!
A repair of the device may only be carried out by a specialist!
•
The device must always be disconnected from the supply voltage after use!
•
If any liquid penetrates into the device, it could be damaged. If you have spilled any
•
liquids in, or over the assembly, the device must be checked by a qualified specialist.
Intended use
The intended use of the device is exclusively the Anycubic® Kobra 3D printers.
Any other use than specified is not permitted!
Safety instructions
When handling products that come into contact with electrical voltage, the applicable VDE
regulations must be observed, in particular VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and
VDE 0860. Always disconnect the power plug before opening a device or ensure that the device is
de-energized.
Things like tools may only be used on devices, components or assemblies if it is ensured
•
that the devices are disconnected from the supply voltage and that electrical charges
stored in the components located in the device have been discharged beforehand.
Live cables or lines to which the device, component or assembly is connected must always
•
be inspected for insulation faults or breaks. If a fault is found in the supply line, the
device must be taken out of operation immediately until the defective line has been
replaced.
When components or assemblies are used, attention must always be drawn to strict
•
compliance with the characteristic data for electrical variables specified in the associated
description.
If it is not clear for the non-commercial end user from an existing description which
•
electrical characteristic values apply to a component or an assembly, how external wiring
is to be carried out or which external components or additional devices may be connected
and which connection values these external components may have, an expert must always
be consulted for information.
Page 3 of 9