Audionet AMP II MAX Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Audionet AMP II MAX. Audionet AMP II MAX 13 pagina's.
Ook voor Audionet AMP II MAX: Gebruikershandleiding (13 pagina's)
Pagina afdrukken
Switching on
Remote power on
Audionet Link
Auto On/Off
Operating
Switch on your AMP II MAX at the rear side. The switch is above the
mains socket. After a short time the line "Audionet" will appear in the
display. Now your AMP II MAX is in stand by mode.
For switching on and off please press the "power" button at the front of
the AMP II MAX. The main switch at the back is only to be used if you
are absent for a longer time and must only be operated while the AMP II
MAX is in stand by mode
Your mono amplifiers AMP II MAX both can be switched on remotely
by several different ways:
§ using "Audionet Link": You switch on or off your AMP II MAX with
your Audionet pre amplifier PRE or PRE I
§ using automatic detection of an input signal: "Auto On/Off"
§ using a countdown of specified time.
(If the unit is in stand by mode you enter the corresponding menu by
pressing the button at the front for longer than 2 seconds.)
For a remote controlled switching on by your Audionet pre amplifier two
simple optical "Toslink" cables are necessary. Connect the output labeled
"audionet link" at your pre amplifier with the "audionet link" input of the
first AMP II MAX. Then connect the "audionet link" output with the sec-
ond optical cable to the "audionet link" input of the second AMP II MAX.
The AMP II MAX is equipped with a multi-stage input signal detection
circuit. If an input signal appears at the input (XLR or cinch) crossing the
user definable threshold your AMP II MAX will switch on automatically.
Due to stereo signals is may occur that both AMP II MAX will switch on
at different points of time.
The amplifiers will function as usual. Of course, you are still able to
switch on and off the units manually.
5