Datavideo DAC-10 Snelle installatie - Pagina 2

Blader online of download pdf Snelle installatie voor {categorie_naam} Datavideo DAC-10. Datavideo DAC-10 4 pagina's. Datavideo dac-10: quick setup
Ook voor Datavideo DAC-10: Snelle installatie (2 pagina's), Gebruiksaanwijzing (10 pagina's)

Pagina afdrukken
Datavideo DAC-10 Snelle installatie
C. Cable connections
Make sure your VCR or Analog source is connected to the inputs of the DAC-10.
A 6-pin FireWire cable can be connected to the rear of the DAC-10. The opposite end should
be connected to your 1394/connector on your computer.
If you would like to monitor your video, a composite BNC video cable can be used to connect
a video monitor. Connect a composite BNC cable from the rear of the DAC-10 and connect
the opposite end to the input of your monitor.
Note: S-video cables only carry a video signal, so you will need to connect your RCA audio
cables to the converter to capture sound.
Helpful Hint: The "OUTPUT" from one device, must go to the "INPUT" on another device.