Gadhouse HENRY Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gadhouse HENRY. Gadhouse HENRY 13 pagina's.

Pagina afdrukken

TROUBLESHOOTING GUIDE

To keep the warranty valid, never try to repair the product yourself. If you
encounter problems when using this product, check the following points
in the table below before requesting service. If the problem remains
unsolved, directly contact customer service
Problem
Make sure the power cord is plugged into
The HENRY turntable
a wall outlet and plug the connector into
does not operate
the power jack on the unit.
Turn off the product, and then turn it on
again.
No power at the power outlet.
Stylus protector is still on.
No sound from the
Tone arm is lift up by the lever.
HENRY turntable.
The Phono/Line switch is set at PHONO
position but RCA jacks connected to the
stereo system's line input.
Forget to connect the speaker to the
turntable.
Power is on, but the
This unit is not in turntable mode. Press
platter does not turn
the MODE button to turntable mode, the
indicator light in red.
Need to press the PLAY / STOP button
once to start playing.
Turntable's drive belt is not installed or
has slipped off.
Read the information under "Initial set
Tone arm
up" topic in this booklet.
will not move
Troubleshooting guide
18
Problem
Lower the lifter lever.
Needle does not
Make sure the replacing new needle is a
lower onto record.
Moving Magnet Cartridge (ATN3600L Dual)
Balance the Counter Weight probably
(see the section Cartridge down force
adjust
Make sure the Speed button Switch is
Music from record
too slow or too fast
correctly set for the record being played
(33, 45, or 78 RPM). (can check the speed
on the record label)
Records keep
Ensure the turntable is on a flat, level
skipping
surface.
Clean the record with a Gadhouse Vinyl
Cleaner (check the product from Gadhouse
online store) to remove build-up of dust in
the grooves of the record before playing.
Ensure the Needle is in the correct position.
Ensure the Needle is not bent or broken by
lightly touching the tip of the needle. (see
more information under "Replacing the
needle" Online here: http://gadhouse.com
/tutorial)
Ensure the record is in good condition.
The Bluetooth reception is poor. Move the
The audio quality is
device closer to this product or remove any
poor after connection
obstacle between.
with a Bluetooth-
Ensure the length between device and
enabled device.
product is not more than 10 Metre.
Troubleshooting guide
19