Gadhouse HENRY Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gadhouse HENRY. Gadhouse HENRY 13 pagina's.

Problem
The device does not support the profiles
Cannot connect
required for this product.
Bluetooth with
The Bluetooth function of the device is not
the HENRY turntable.
enabled. Check the user manual of the
device to find out how to enable the
function.
Ensure this product is not in the pairing
mode.
This product is already connected with
another Bluetooth-enabled device. Discon-
nect that device and then try again.
Ensure the Mode is operate as "Bluetooth"
function
NOTE:
1. Simultaneous use with other devices
Failure, such as the interruption of sound, may
be caused by radio wave interference from
devices that use the same frequency band
(2.4GHz) as the turntable, including devices
with Bluetooth wireless technology, devices
using wireless LAN, digital cordless phones
and microwaves. Similarly, because radio
waves of the turntable may affect these
devices, take the following precautions:
- Install the devices using the same frequency
band (2.4GHz) away from the turntable.
2. Any device which is connected to the
turntable needs to meet the Bluetooth stand-
ards established by Bluetooth SIG and be
certified. Even if the device meets the Blue-
tooth standards, it might not connect to the
turntable or the operation method and behav-
iour may differ depending on the device's
characteristics and specification.
Troubleshooting guide
20
Problem
The paired device
The Bluetooth reception is poor. Move the
connects and
device closer to this product or remove any
disconnects
obstacle between.
Ensure the length between device and
constantly.
product is not more than 10 Metre.
Some mobile phones may connect and
disconnect constantly when you make or
end calls. This does not indicate any
malfunction of this product.
For some devices, the Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
This model use Moving Magnet Cartridge
How-to Replacing
(ATN3600L Dual), insist upon a genuine
the new stylus
the product at Gadhouse online store
(http://www.gadhouse.com/shop).
and see tutorial page for instruction.
See the below section of Cartridge
Replacement
Strong hum on
The cable is not grounded correctly.
phono input

CARTRIDGE REPLACEMENT

1. Before replacement, put the stylus protector back on the stylus to
prevent damage to the stylus during the replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the
cartridge and then remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not
completely tighten the screws at this moment.
Troubleshooting guide
21