DBZ DMi 2/4000A Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DBZ DMi 2/4000A. DBZ DMi 2/4000A 20 pagina's. Professional power amplifier

Binding Post Connection

At the end of each speaker cable,

peel off the 15mm-long insulation and place

the bare wire through the appropriate binding

post of the speaker. Tighten the posts until they

grip the wire firmly. Refer to the socket for the

polarity of the speaker.

CH1

BRG

CH2

1 .Switch off POWER.

2 .Plug the Neutrik NL4FC into Speakon socket on the rear panel of amplifier, and then lock it clockwise.

At the end of each speaker cable, peel off the 15mm-long insulation and place the bare wire through the

appropriate binding post of the speaker. Tighten the posts until they grip the wire firmly. Refer to the

socket for the polarity of the speaker.

Connectors Introduction

XLR input connector connection

diagram is as below:

Pin 1 is grounded / shielded, pin 2 is positive (+),

pin 3 is negative (-),

Balanced XLR wiring diagram

Unbalanced XLR wiring diagram

Description：

When the input signal source is unbalanced mode

(single-ended) input, XLR Pin 1 and Pin 3 can be

connected in parallel.

But unbalanced signal cable should not be too long,

otherwise it will lead to line noise (hum) , it is

recommended as far as possible to use balanced

input connection mode to improve noise suppression.