Avantco 177MX40H Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Avantco 177MX40H. Avantco 177MX40H 9 pagina's. Planetary floor mixer

Operation

CAUTION

•

ALWAYS turn off the machine before changing speeds. Failure to do so may damage the gearbox

and void the warranty.

•

ALWAYS make sure the bowl is securely attached and in the fully lifted position and the safety guard

is closed before operation.

•

DO NOT run the mixer with hub accessory and agitator at the same time.

•

Bowl lift handle is supplied loose and can be used to raise and lower the bowl in the event of a

power failure. THIS HANDLE MUST NOT BE FITTED IN NORMAL OPERATION.

Open the safety guard and lower the bowl using the bowl lift handle.

2. Affix the appropriate attachment to the agitator by raising it onto the mixing axle and rotating

clockwise on the shaft until it locks into place. To remove, raise the agitator on the shaft until it clears

the lock and then rotate counterclockwise and lower. (See Attachment Guide on Page 6-7.)

3. Load product into the bowl, being careful to not over load. (See Mixer Capacity Chart on Page 6.)

4. Raise the bowl into position using the bowl lift controls.

5. Close the safety guard.

NOTE: The machine will not operate if the guard and bowl are in incorrect/lowered positions.

6. Set the timer to desired operating time between 1-30 minutes.

NOTE: The timer does not require adjustment for every cycle and will default to pre-set time until

changed by the operator.

Set the desired mixing speed using the handle suitable for the attachment fitted and product being

processed. (See Mixer Capacity Chart on Page 6.)

•

Low Speed: Position 1, knob facing forwards.

•

Medium Speed: Position 2, knob facing up.

•

High Speed: Position 3, knob facing down.

8. After time and speed have been set, press the ON button. The unit will run for the time period set and

then switch OFF automatically.

9. The red emergency STOP button will shut down the machine at any time during the cycle.

Using the Attachment Hub

Turn the mixer OFF and remove any agitator attachment.

2. Loosen the hub mounting screw and remove the attachment hub cover.

3. Insert and align the attachment shaft into the attachment hub and ensure the attachment is fully inserted.

4. Tighten the hub mounting screw.

5. Operate according to directions above, starting with step 4.

User Manual

60 Qt. Planetary Floor Mixer