ALIBI ALI-IPV5060RP Snelle installatiehandleiding - Pagina 2

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} ALIBI ALI-IPV5060RP. ALIBI ALI-IPV5060RP 7 pagina's. 6mp 360 fisheye ip camera

Pagina afdrukken

Bezel retention

tab slots

Access to MicroSD card

slot and Reset button

(cover removed)

Camera face with bezel removed

Insert MicroSD card into the camera

A MicroSD card installed in the provides local storage for video recordings, capture files, and log data.

NOTE: If the camera is not managed by an NVR or other video management system (VMS) and doesn't

have a MicroSD card installed, video recordings, capture files, and log data are not saved.

Remove the bezel.

Use the security L-wrench to remove the oval cover that conceals the MicroSD card slot and the

Reset button.

Insert a MicroSD card into the card slot as shown in the photo below. The label on the card should

face out.

MicroSD card

shown in slot

Push the MicroSD card into the slot as far as possible, and then release it. It should click into place

when fully inserted.

MicroSD card

installed

www.observint.com

Bezel tether

and bezel

Slots for

mounting screws

To remove the MicroSD card, push the card all the way in to release it from the connector, then lift it

out of the slot.

Reinstall the oval shaped cover that conceals the MicroSD card and the Reset button.

Step 3.

Mount the camera

Use the following procedure to flush-mount the camera onto a ceiling or wall. The procedure is identical for

all three, except for a parameter difference in the camera setup menu, and the orientation of the camera for

wall installations, and. Pictures shown here are for a ceiling installation.

Route extension cables from the camera mounting location to the devices it will connect to. Do

not connect them to these devices at this time. The camera provides the following drop cables to

connect to other devices:

Power with screw-down terminals for 12 Vdc powering. NOTE: The camera can also be

—

powered through the LAN (PoE).

Ethernet with RJ-45 connector. A protective jacket for the RJ-45 connector is provided with

—

the camera.

Alarm IN/OUT with screw-down terminals. Terminal identification is provided on the

—

connector.

Alarm terminal

identifiers

RS485 drop cable with screw-down terminals. Terminal identification is provided on the

—

connector.

Audio IN

—

Audio OUT

—

Prepare the camera for installation. See "Step 2. Prepare the camera for installation" on page 1.

Obtain the appropriate fasteners for securing the camera to the mounting surface. The fasteners

should support at least three times the weight of the camera. The screws and wall inserts provided

with the camera are adequate for many surfaces.

Use the Drill Template provided to mark and drill the holes in the ceiling for the fasteners (mounting

screws). Also drill a hole for the drop cables. For wall mount installation, orient the template so that

the arrow points up (perpendicular to the plane of your surveillance target).

For wall mount installation, the camera must be oriented so the "UP" label on the face of the

NOTE

camera is at the top.

"UP" label

Camera Reset

Install screws into the screw hole until the screw head is at least ¼" over the surface.

button

RS485 terminal

identifiers (D+, D-)