ALIBI ALI-IPV5060RP Snelle installatiehandleiding - Pagina 3

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} ALIBI ALI-IPV5060RP. ALIBI ALI-IPV5060RP 7 pagina's. 6mp 360 fisheye ip camera

Pagina afdrukken

Connect the extension cables to the camera drop cables. Use the protective jacket for the LAN cable

connector, if needed.

NOTE

Drop cable connectors are not waterproof.

Position the camera at the mounting location so that the screws heads are in the mounting screw

slots, and then turn the camera clockwise until the screws are fully seated in the slots.

Tighten the mounting screws until snug. Be careful not to over-tighten them.

Connect the extension cables to the devices the camera will connect to. Be sure the devices you

connect the cables to are not powered on.

10.

Apply power to the devices the camera is connected to, including 12 Vdc power or LAN PoE.

11.

Reinstall the camera bezel.

12.

Remove the protective film from the camera lens dome. Clean the dome with isopropyl alcohol if

needed.

13.

Using a computer connected to the LAN the camera is attached to, configure the network access to

the camera including:

Install Alibi Discover (see "Step 4. Install the Alibi Discover Tool" on page 3).

—

Configure the network settings (see "Step 5. Change device network settings (IP address)"

—

on page 3).

14.

Log into camera to perform camera setup procedures including:

—

Configure camera fisheye parameters (see "Step 7. Setup Fisheye Parameters" on page 5).

—

For ceiling mounted cameras, select the Mount Type as "Ceiling". For wall mounted

cameras, select the Mount Type as "Wall". For table mounted cameras, select the Mount

Type as "Table".

Configure PTZ camera video streams (see"Step 9. Setup PTZ video streams" on page 5).

—

Change administrative password. See "Step 10. Change default password" on page 6.

—

Perform advanced camera configuration steps as needed. Refer to the ALIBI™ IP Camera

15.

Software User Manual provided on CD with your system, or on your vendor's website. These

configure steps should include the following:

Configuring alarm input and output

—

Configure recording schedules

—

Configure event recording (motion detection, traversing virtual plane, intrusion, etc.)

—

Traversing Virtual Plane Detection

—

Intrusion Detection

—

Add access users to the camera

—

Step 4.

Install the Alibi Discover Tool

The ALIBI Discover Tool is a software utility used to "discover" ALIBI cameras and NVRs/DVRs installed on

the LAN and change their network settings. The tool is provided on the CD with your camera. To use the

tool:

Insert the software CD provided with your camera into an optical drive on the Microsoft Windows

computer you will use to access your camera on the LAN.

On the CD, find the folder that contains the ALIBI Discover Tool.

Copy the files in the folder to a new directory on your computer. The files should appear as shown in

the directory shown below.

www.observint.com

To open the ALIBI Discover Tool, double click the file ALIBI Discover Tool.exe. The tool will

automatically discover ALIBI cameras and recorders installed on the network.

Step 5.

Change device network settings (IP address)

To change the network settings of the camera to be compatible with the subnet where it is installed, do the

following:

Click the device to highlight it. Notice that the network parameters are shown in the right frame.

Modify the network settings to values compatible with the subnet where it is installed.

Enter the admin password for the device in the password field. By default, the admin user

password for ALIBI cameras is 1111.

Click the Save button. A parameter modification completion window will open.