AlkaWay HIM-19 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AlkaWay HIM-19. AlkaWay HIM-19 8 pagina's. Hydrogen inhaler

4. Precautions

1. For adult use only.

2. Use only distilled water with a TDS of less than 3 to avoid voiding your warranty.

Water with a TDS greater than 3 WILL damage the Cell. For the recommended brand

of distilled water contact our Sales Support Team - 1800 268 469.

3. Always use in a well-ventilated or spacious room.

4. Operating temperature 5 to 30°C with a relative humidity of between 25 to 75°.

5. Do NOT use near an open flame (including smoke, burning incense or cigarettes) or a

heater, or anything that sparks or has an open flame (within 3m).

6. Do NOT use when going to sleep. Remain awake at all times when using the

machine.

7. Keep the power plug away from water.

8. Do NOT block the hydrogen and oxygen outlet holes when using the machine.

Blocking these outlets will void the warranty.

9. Do NOT connect the bubbler to the Oxygen outlet, as the back pressure will cause

damage to the cell and will void the warranty.

10. To maximise and maintain the optimal efficiency, the hydrogen generator should be

rested for 2-3 hours after more than 2 consecutive hours of use. After each shorter

time session, it is ideal to rest the machine off for 1-2 hours.

11. Don't use the machine without water in it, this too voids the warranty.

5. Creating Hydrogen water with the bubbler

1. Push one end of the white connection tube onto

the small end of the nano-rod bubbler.

2. Push the other end of the white connection tube

onto the Hydrogen outlet on the machine.

3. Keep the Oxygen outlet open (not covered).

4. Place the larger end of the bubbler into a glass of

water and start the machine.

5. Set the flow rate to 150ml/min.

6. Hydrogen-rich water will take between 5-10

minutes. So, stop the machine after 10 minutes.

Hint:

The colder the water the more Hydrogen can be

absorbed by the water.

Caution: Only connect the bubbler assembly to the Hydrogen outlet. DO NOT connect it to the

Oxygen outlet, as the back pressure will cause damage to the Cell and will void the warranty.

Stainless steel nano-rod bubbler

White connection tube