Brother DCP-9040CN Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Brother DCP-9040CN. Brother DCP-9040CN 10 pagina's. Facsimile equipment
Ook voor Brother DCP-9040CN: Brochure & specificaties (4 pagina's), Handleiding voor snelle installatie (30 pagina's), Handmatig (7 pagina's), Referentielijst onderdelen (43 pagina's), Handleiding voor snelle installatie (31 pagina's), Reiniging en onderhoud (7 pagina's), Handleiding voor snelle installatie (20 pagina's)

DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW

IMPORTANT! READ THIS PROCEDURE IN ITS ENTIRETY BEFORE ATTEMPTING THE PROCEDURE.

UNSUCCESSFUL REPAIR OR DAMAGE MAY RESULT FROM IMPROPER INSTALLATION.

Symptom:

Customer reports a "NO PAPER FED" message when attempting to feed paper from cassette and/or hears a

"popping" noise when attempting to feed paper and the paper does not leave the paper tray.

Possible cause:

The paper (PE) actuator is stuck in the wrong position and or there is damage to the paper feed frame unit.

PE Actuator is in the

Recommendation:

Replace the paper feed frame unit.

PAPER FEED FRAME ASSEMBLY – REMOVAL

Remove the consumables:

1. Power off the machine and disconnect the power cord. Remove the paper tray from the machine.

2. Open the front door. Remove the drum/toners, belt unit and the waste toner pack (both located under the

drum unit). Important – place the drum unit on a flat surface and protect the drum unit from excessive

bright light.

Remove the outer covers:

1. Remove the two screws securing the back cover. Remove the back cover.

NO PAPER FEED Message, Clicking Noise

March 3, 2008

No paper fed

noise.wav

incorrect

position

Page 1 of 10

SERVICE

UPDATE No.

PE Actuator is in the

correct

position

F1249