Brother DCP-9040CN Hızlı Başlangıç Kılavuzu

Yazıcı Brother DCP-9040CN için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Brother DCP-9040CN 10 sayfaları. Facsimile equipment
Ayrıca Brother DCP-9040CN için: Broşür ve Teknik Özellikler (4 sayfalar), Hızlı Kurulum Kılavuzu (30 sayfalar), Manuel (7 sayfalar), Parça Referans Listesi (43 sayfalar), Hızlı Kurulum Kılavuzu (31 sayfalar), Temizlik ve Bakım (7 sayfalar), Hızlı Kurulum Kılavuzu (20 sayfalar)

Sayfayı Yazdır
Brother DCP-9040CN Hızlı Başlangıç Kılavuzu
DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW
IMPORTANT! READ THIS PROCEDURE IN ITS ENTIRETY BEFORE ATTEMPTING THE PROCEDURE.
UNSUCCESSFUL REPAIR OR DAMAGE MAY RESULT FROM IMPROPER INSTALLATION.
Symptom:
Customer reports a "NO PAPER FED" message when attempting to feed paper from cassette and/or hears a
"popping" noise when attempting to feed paper and the paper does not leave the paper tray.
Possible cause:
The paper (PE) actuator is stuck in the wrong position and or there is damage to the paper feed frame unit.
PE Actuator is in the
Recommendation:
Replace the paper feed frame unit.
PAPER FEED FRAME ASSEMBLY – REMOVAL
Remove the consumables:
1. Power off the machine and disconnect the power cord. Remove the paper tray from the machine.
2. Open the front door. Remove the drum/toners, belt unit and the waste toner pack (both located under the
drum unit). Important – place the drum unit on a flat surface and protect the drum unit from excessive
bright light.
Remove the outer covers:
1. Remove the two screws securing the back cover. Remove the back cover.
NO PAPER FEED Message, Clicking Noise
March 3, 2008
No paper fed
noise.wav
incorrect
position
Page 1 of 10
SERVICE
UPDATE No.
PE Actuator is in the
correct
position
F1249