Fujitsu Eternus DX90 S2 Configuratiehandleiding - Pagina 15

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Fujitsu Eternus DX90 S2. Fujitsu Eternus DX90 S2 38 pagina's. Server connection. (fibre channel) for aix
Ook voor Fujitsu Eternus DX90 S2: Gebruikershandleiding (35 pagina's), Gebruikershandleiding (42 pagina's), Handmatig (18 pagina's), Installeer setup (20 pagina's), Configuratiehandleiding Serververbinding (13 pagina's), Hardware-installatie (23 pagina's), Configuratiehandleiding (28 pagina's), Configuratiehandleiding (15 pagina's)

Chapter 3

Notes

3.10

Virtual I/O Server (VIOS) Notes

3.10

Virtual I/O Server (VIOS) Notes

Perform the settings described in this manual only for a VIOS.

•

When performing VIOS settings or installing software, the root privilege for the VIOS environment is re-

quired.

To use a VIOS, ETERNUS Multipath Driver 2 (AIX) or FJSVmpio is required. Install ETERNUS Multipath Driver 2

•

(AIX) or FJSVmpio in the VIOS.

Configuring LVM on the VIOS is not supported.

•

3.11

Set the CSS miscount parameter to a value of 60 or higher.

•

Set "fc_err_recov", an "fscsi" attribute, to "fast_fail".

•

3.12

Added paths may not be automatically recognized if the OS is not rebooted after adding the paths. In that

case, execute the following command.

#cfgmgr

In addition, if Veritas Volume Manager (VxVM) is used, execute the following command.

#vxdctl enable

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for AIX

P3AM-3782-23ENZ0