Dell PowerEdge M710 Technisch handboek - Pagina 23

Blader online of download pdf Technisch handboek voor {categorie_naam} Dell PowerEdge M710. Dell PowerEdge M710 31 pagina's. Dell poweredge blade servers getting started guide
Ook voor Dell PowerEdge M710: Informatie-update (38 pagina's), Handleiding bijwerken (44 pagina's), Handleiding bijwerken (21 pagina's), Handleiding bijwerken (14 pagina's), Installatiehandleiding (7 pagina's), Handleiding bijwerken (1 pagina's), Aan de slag handleiding (12 pagina's), Aan de slag handleiding (12 pagina's), Portfolio Handleiding (27 pagina's), Aan de slag handleiding (14 pagina's), Aan de slag handleiding (12 pagina's)

Dell™ PowerEdge™ M710 Technical Guidebook

sectiOn 11. stORaGe

a. hard Drive Overview / Description

The PowerEdge M710 supports 4 2.5" hard drives. These drives can be either SAS or SSD.

RAID 0, RAID 1, and RAID 5 are supported as long as a RAID card is included.

Hard drives must use the new Dell Hannibal drive carrier for 2.5" drives.

For the slots that are not occupied by drives, a carrier blank is provided to maintain proper cooling,

maintain a uniform appearance to the unit, and provide EMI shielding.

The system supports diskless configuration with no storage controller installed in the system.

Each disk drive carrier has two LED indicators visible from the front of the system. One is a green LED

for disk activity and the other is a bi-color (green/amber) LED for status information. The activity LED

is driven by the disk drive during normal operation. The bi-color LED is controlled by the SEP device on

the backplane. Both LEDs are used to indicate certain conditions under direction of a storage controller.

b. storage controllers

The PowerEdge M710 will support a variety of RAID cards:

• C ERC6 - The M710 supports this card with 128MB of RAID cache.

a. Overview / Description

The PowerEdge M710 Integrated Dell Remote Access Controller 6 (iDRAC6) incorporates an integrated

video subsystem, connected to the 32-bit PCI interface of the ICH9. This logic is based on the Matrox

G200 with 8MB of cache. The device only supports 2D graphics. The video device outputs are multiplexed

between the front and rear video ports. If a monitor is connected to the front video connector, it will

take precedence over the rear connection, thereby removing the display from the rear connection.

The PowerEdge M710 system supports the following 2D graphics video modes:

ResOlutiOn

640 x 480

800 x 600

1024 x 768

1152 x 864

1280 x 1024

RefResh Rate (hz)

60, 72, 75, 85

56, 60, 72, 75, 85

60, 72, 75, 85

60, 75, 85

cOlOR DePth (bit)

8, 16, 32

8, 16