AQUAPHOR RO-70S Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AQUAPHOR RO-70S. AQUAPHOR RO-70S 13 pagina's. Drinking water machine

Pagina afdrukken

Installation of the water

conditioning cartridge (fig. 7)

• Install the bracket for the conditioning

cartridge on the RO-70S trim cover

and secure it with a self-tapping

screw, as shown in fig. 7a.

• Before connecting the post-filter,

remove the transport plugs installed

in the JG sockets at the input and

during the post-filter (see the

Disconnection of the JG tubes).

• Place the post-filter in the bracket by

pressing on the post-filter, as shown in

fig. 7b.

Connect the JG 1/4" blue (d 6.35 mm) L = 0.17 m inlet fitting (fig. 13) to the RO-70S body in accordance

with the diagram (fig. 2).

6. STARTING RO-70S

To start the RO-70S, it is necessary to connect the supply pipes and carry out the procedure for rinsing the

cartridges and the membrane.

Step 1. Connect the supply pipes by following the diagrams below.

The connection diagram of the tubes is shown in fig. 2.

Connection of JG tubes

Pull the locking clip (2) out from under the plastic

sleeve (1), insert the pre-wetted end of the tube (3) into

the sleeve bushing to a depth of approximately 15 mm

to the stop and install the clip (2) into place. Check the

strength of the tube (3): at an effort of 8–10 kg, the tube

should not be able to be pulled out.

Step 2. Preparation of the water purifier for operation

• Remove the lid from the water purifier by turning the three latches anticlockwise by 90 °C (Fig. 8).

• Remove the service plug (fig. 9), which is located under

the lid of the water purifier.

• Remove the shrink film from the K3 (K6) cartridge and

remove the transport plug (if any).

• Moisten the O-rings on the plugs of the cartridges

under running water.

For convenience, the stop buttons on the manifolds

have a different color. Install the filter cartridge K3 and

service plug (fig. 10) in the order indicated in Table 1.

Self-drilling

screw

Figure 7

Disconnection of JG tubes

Pull the locking clip (2) out from under the

plastic sleeve (1) and pull the tube (3) by pressing

the end of the plastic sleeve. For depressing, use

the wrench (4) to disconnect the tubes that is

included in the water purifier kit.

Figure 8

Figure 9

AQUAPHOR RO-70S | Owner's manual