BURL B16-BMB2 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} BURL B16-BMB2. BURL B16-BMB2 4 pagina's. Mothership

1. GETTING STARTED

1.1 Register

Please register all serial numbers for your B16 MOTHERSHIP chassis and all Daughter Cards.

You must register to activate your warranty! Please visit: www.burlaudio.com/register.

1.2 Install Daughter Cards (If Necessary)

If the Daughter Cards have been pre-installed, skip to page 3, step 1.8.

1.3 Remove Lid

Remove 9 screws on top and 2 on each side (Image 1).

Push lid up from card slot (Image 2).

Image 1: Top view shows location of 4

screws on side before removing the lid.

1.4 Verify Jumper Settings On BMB2

Find H6 on the BMB2 Motherboard, as shown in Image 3 below.

Jumpers should be on 1 and 8 for use with B16 MOTHERSHIP.

Image 2: Push lid up.

Image 3: Locate the H6 Header

on BMB2 Motherboard. From the

rear of the chassis, BMB2 is on

the bottom left. The H6 Header is

highlighted.

For B16, jumpers must be on 1

and 8.