Olympus BH2 Series Handleiding voor probleemoplossing en afstelling - Pagina 32
Blader online of download pdf Handleiding voor probleemoplossing en afstelling voor {categorie_naam} Olympus BH2 Series. Olympus BH2 Series 46 pagina's. Phase contrast
Ook voor Olympus BH2 Series: Volledige demontage, reiniging en hermontage (23 pagina's), Volledige demontage, reiniging en hermontage (40 pagina's), Demontage, reiniging en hermontage (45 pagina's), Handmatig (6 pagina's), Installatiehandleiding (9 pagina's)
Pagina afdrukken
D.
TROUBLESHOOTING (B2-BDS-3)
No. D-1
l.
Hints for Using
This Manual
This manual is written in the flowchart format.
Follow the arrow
mark to find out a defective
part.
The
numbers
and symbols like \H-lj
and
jw-2j indicate the numbers of
connector
and pin.
"Between
IH-11
and
IW-21"
means "Connect HOT to IH-lland GND to lw-21
when
measuring
with
a multimeter".
GND-+ A reference
voltage, OV, in an electronic circuit.
HOT -+ A
line to apply a supply
voltage.
The symbols like
®
and
@
mean "Jump to
®
and
@
in the same item".
The
symbols
®
and
@
mean "Proceed the work according to the
check
methods
®
and
@
given in the
same
item".
*
Be sure to
set up the unit before turning on the main switch.
A
terminal is exposed at
rn:=IJ
and I
W-2~
Measure at the exposed part
without removing.
The electrical
base for BHS is available in B2-BDS-2 and B2-BDS-3.
Refer
to the manuals for each model.
The difference in the
appearance
of the two models is shown below.
--------
B2-BDS-2
B2-BDS-3
LED
calor
Red
Green
Primary voltage
YES
NO
selector switch
lOOV
AB098800
AB615900
Nameplate
channel
AB099900
AB616100
200V
AB098900
AB6
1
6000
Channel
ABlOOOOO
AB616200
YES
The selector switch is
provided.
NO
The selector switch is not
provided.
The
nameplates
are compared on the next page.