Cisco UCS B200 M4 Upgrade handleiding - Pagina 2

Blader online of download pdf Upgrade handleiding voor {categorie_naam} Cisco UCS B200 M4. Cisco UCS B200 M4 9 pagina's. For e5-2600 v4 series cpus
Ook voor Cisco UCS B200 M4: Installatie en onderhoud (30 pagina's), Installatie en onderhoud (46 pagina's), Onderhoudshandleiding (24 pagina's)

Pagina afdrukken

Upgrade Scenario: UCS Manager and the BIOS Software are Earlier Than the Minimum Supported Release Version,

and the Server has Intel E5-2600 v3 Series CPUs

Cisco UCS Manager Release 2.2(4) introduced a server pack feature that allows Intel E5-2600 v4 CPUs

Note

to run with Cisco UCS Manager Release 2.2(4) or later, provided that the CIMC, BIOS, and Capability

Catalog are all running Release 2.2(7) or later.

Upgrade Scenario: UCS Manager and the BIOS Software are Earlier Than the

Minimum Supported Release Version, and the Server has Intel E5-2600 v3

Series CPUs

Before You Begin

This scenario assumes the following conditions:

• The Cisco UCS Manager software is at a version earlier than the minimum required version.

• The server is at a BIOS/CIMC version earlier than the minimum required version.

• The server is using CPUs earlier than Intel E5-2600 v4 Series.

Step 1

Upgrade the Cisco UCS Manager infrastructure firmware to Release 2.2(4) or later.

Step 2

Upgrade the Capability Catalog to Release 2.2(7) or later. Use the procedures in the

Management Guide

Step 3

Use Cisco UCS Manager to upgrade and activate the server CIMC to Release 2.2(7) or later. Use the procedures in the

appropriate upgrade guide (depending on your current software version):

Step 4

Use Cisco UCS Manager to upgrade and activate the server BIOS to Release 2.2(7) or later. Use the procedures in the

appropriate upgrade guide (depending on your current software version):

Step 5

Disassociate the server in Cisco UCS Manager.

Step 6

Power off the server.

Step 7

Remove the server from the chassis.

Step 8

Replace the CPUs with the Intel E5-2600 v4 Series CPUs. At this time, you might also be upgrading the memory to

2400 MHz DIMMs or making other server configuration changes. Use the procedures in the

Server Installation and Service

Step 9

Reinsert the server in the chassis.

Step 10

Wait for Cisco UCS Manager to automatically discover the server.

At this point, the Health LED of the server shows a critical fault and Cisco UCS Manager reports a generic error

Note

message:

is required, which is described in the next step.

Step 11

Wait for Cisco UCS Manager to automatically activate the board controller version.

Note

The

show image

server. Always activate the latest board controller image version when you use the

The server automatically reboots after it exectues the

Note

# scope server <chassis/srever>

# scope boardcontroller

Cisco UCS B200 M4 Server Upgrade Guide for E5-2600 v4 Series CPUs

to update the Capability Catalog.

Note.

WILL_BOOT_FAULT: Sensor failure asserted

command in the sequence below lists the board controller versions that are available for the

Cisco UCS Manager Firmware

Cisco UCS Manager Upgrade

. This error occurs because a board controller activation

command.

commit-buffer

Introduction

Guides.

Cisco UCS B200 M4 Blade

command.

activate firmware