Cisco UCS B200 M4 Upgrade handleiding - Pagina 4

Blader online of download pdf Upgrade handleiding voor {categorie_naam} Cisco UCS B200 M4. Cisco UCS B200 M4 9 pagina's. For e5-2600 v4 series cpus
Ook voor Cisco UCS B200 M4: Installatie en onderhoud (30 pagina's), Installatie en onderhoud (46 pagina's), Onderhoudshandleiding (24 pagina's)

Pagina afdrukken

Upgrade Scenario: UCS Manager and the BIOS Software are at the Minimum Supported Release Version, and the

Server has Intel E5-2600 v3 Series CPUs

• The server is using Intel E5-2600 v3 Series CPUs.

Step 1

Upgrade the UCSM Capability Catalog to Release 2.2(7) or later. Use the procedures in the

Management Guide

Step 2

Use Cisco UCS Manager to upgrade and activate the server CIMC to Release 2.2(7) or later. Use the procedures in the

appropriate upgrade guide (depending on your current software version):

Step 3

Use Cisco UCS Manager to upgrade and activate the server BIOS to Release 2.2(7) or later. Use the procedures in the

appropriate upgrade guide (depending on your current software version):

Step 4

Disassociate the server in Cisco UCS Manager.

Step 5

Power off the server.

Step 6

Remove the server from the chassis.

Step 7

Replace the CPUs with the Intel E5-2600 v4 Series CPUs. At this time, you might also be upgrading the memory to

2400 MHz DIMMs, or making other server configuration changes. Use the procedures in the

Server Installation and Service

Step 8

Reinsert the server in the chassis.

Step 9

Wait for Cisco UCS Manager to automatically discover the server.

Step 10

Wait for Cisco UCS Manager to automatically activate the board controller version.

Step 11

Do not continue with the next step until board controller activation completes. Verify that the activation is complete by

using the

show image

successfully.

# show version

Boardcontroller:

Running-Vers: x.0

Package_Vers:

Activate-Status: Ready

Step 12

Use the Cisco UCS Manager GUI to clear the WILL_BOOT_FAULT and reset the server CIMC:

a) In the Navigation pane, click the Equipment tab.

b) On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose your server.

c) In the Work pane, click the General tab.

d) In the Actions area, click Recover Server.

e) In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.

Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This process takes two

to three minutes. At the end of the process, the WILL_BOOT_FAULT is cleared.

Cisco UCS B200 M4 Server Upgrade Guide for E5-2600 v4 Series CPUs

to update the Capability Catalog.

Note.

command to see that Activate-Status returns Ready. This process takes a few minutes to complete

Cisco UCS Manager Firmware

Cisco UCS Manager Upgrade

Cisco UCS B200 M4 Blade

Introduction

Guides.