DNP IDW520 Opstarthandleiding - Pagina 4

Blader online of download pdf Opstarthandleiding voor {categorie_naam} DNP IDW520. DNP IDW520 17 pagina's. Id photo system
Ook voor DNP IDW520: Snelstarthandleiding (17 pagina's)

Pagina afdrukken

IDW520 Photo ID System

battery in the battery compartment and

the SD card in the card slot. The battery

compartment and SD card slot are located

on the bottom of the camera. Close the door.

• Use the supplied charging cable and plug

to charge the camera battery. The charging

port is on the side of the camera inside the HDMI compartment. Plug

the cable into the charge port and the plug adaptor, then plug the

adaptor into a wall outlet.

• Make sure the camera is OFF before

charging (the camera will not charge if it is

powered ON. When the red light appears

on the top of the camera, the battery is

charging. The camera battery must be

charged prior to use.

• Connect the camera strap and lens lanyard

to the camera.

2. Setting up the Printer

• Unpack the printer. Remove any packaging foam or

tape from the outside of the printer.

• Plug it in. Plug the USB cable into the back of the

printer. Plug the power cord into the back of the printer

and into the wall outlet. Switch the printer power button to ON.

• Open the printer. Press the release lever on top of the printer to

open the media door (left image). Remove the paper spools (and any

packaging materials!). Remove the spacers from the printer spools

and set them in a safe place. The spacers are not needed when using

ID Photo media.

• Load the paper. Remove the paper spools from the paper

compartment. Locate your media box and remove a roll of paper.

1. Preparing the Camera

•

Unpack the camera.

•

Locate the Wi-Fi SD card that was shipped in

the box with your console kit.

•

Place the rechargeable