BlueSky Mast AL3 Series Snelle referentieblad
Blader online of download pdf Snelle referentieblad voor {categorie_naam} BlueSky Mast AL3 Series. BlueSky Mast AL3 Series 6 pagina's.
Ook voor BlueSky Mast AL3 Series: Snelle referentieblad (6 pagina's)
Pagina afdrukkenAL3 Lift Series - Deployment Quick Reference Sheet
1
Stand the tripod up and release
the large Velcro Strap at the
bottom.
6
Add the
Blue Secondary Guy
Ring
then the
Red Primary Guy
Ring. Do not secure them.
11
Attach the winch handle. Pay out
the cable by turning the winch
handle counter clockwise
16
Release the Velcro strap hold-
ing the tripod strut on each of
the 3 tripod legs.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2013 Allendale LLC All Rights Reserved
2
Open the tripod legs and lock
the cross bars. Push them all
the way down to fully engaged.
7
Mount your equipment to the
mounting pole, connect and
secure all cables.
12
Locate the
lift base plate
and
insert it into the bottom of the
mounting pole.
17
Center the strut base plate
under the tripod and align with
the 3 tripod struts.
3
Extend the 2 tripod legs adja-
cent to the winch. DO NOT
extend the tilt leg at this time.
8
Extend the tilt leg and tighten
the turn knob. Make sure all
tripod struts are facing inward.
13
Pass the cable through the 2
rollers on the lift base plate.
18
Loosen the turn knobs on the
struts and extend them towards
the strut base plate.
Read Manual Before Use
Refer to detailed instructions in the
AL3 Lift Series Manual at all times
4
Stake ONLY the Left Holes on
the base plates of the 2 ex-
tended tripod legs.
9
9
Level the tripod by adjusting the
tripod legs. Make sure all 3
bubble levels read level.
14
Pull the pin to secure the ball
stop. Confirm the cable is taut
and the lift base plate is secure.
19
Insert all 3 struts into the
receivers on the strut base plate
and secure the hitch pins.
5
Insert the mounting pole until 1
hole is showing below the cam
lock and lock the cam lock.
10
Stake the remaining holes on all
3 tripod legs.
15
Locate the
strut base plate
and
place directly under the tripod.
20
Make sure the strut base plate
is centered under the tripod and
tighten all turn knobs.