Aktakom ATK-2011 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe Aktakom ATK-2011. Aktakom ATK-2011 11 stron. Clamp meter

III.2.1. True RMS value of AC Voltage

a. Set the sliding switch at position V.

b. Insert the test leads into the input jack. Connect the test prods of the test leads in PARALLEL to the circuit to

be measured.

c. Read the measured RMS value from the LCD display.

NOTE: If the true RMS value is less than 10V, the frequency of the signal will be displayed as 0 (Please refer to the

following figure).