Aktakom ATK-2011 사용자 설명서 - 페이지 8

{카테고리_이름} Aktakom ATK-2011에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ATK-2011 11 페이지. Clamp meter

III.2.1. True RMS value of AC Voltage

a. Set the sliding switch at position V.

b. Insert the test leads into the input jack. Connect the test prods of the test leads in PARALLEL to the circuit to

be measured.

c. Read the measured RMS value from the LCD display.

NOTE: If the true RMS value is less than 10V, the frequency of the signal will be displayed as 0 (Please refer to the

following figure).