flyingwings Hornet Mini FPV Racer Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka flyingwings Hornet Mini FPV Racer. flyingwings Hornet Mini FPV Racer 10 stron.

STEP

Radio Installation:

Set up your servos as shown in the Radio Setup section and

double check everything is working in the correct manner outside

of the model before installing it into the model.

Two pre-cut holes have been made into the wing, these give you

a guide to fit your servos. All micro servos vary in size a little,

so you may have to cut around the servo to sit them into a

snug fitting hole, take your time with this.

1. Place your servo over the hole, draw around it to show

where more foam needs to be removed.

2. cut carefully around, the line draw and prize out the

foam, keep checking for fit with servo.

3. Cut a line around 2mm deep (no deeper) from the servo

cable wire output to the receiver location, push the cable into the

slot.

STEP

Attaching the elevon horn.

The push rod should run parallel to the centre line of the wing.

Using a ruller draw a line on the elevon where the horn should be

situated. Press one of the horns into the foam to leave an

impression, cut this with a knife so that the horn sits in the elevon

around half depth, glue in with plenty of CA glue.

USE SERVO TEMPLATE

SHEET

Horn location