flyingwings Hornet Mini FPV Racer Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka flyingwings Hornet Mini FPV Racer. flyingwings Hornet Mini FPV Racer 10 stron.

STEP

Push rod assembly:

Glue the plastic clevises onto the end of each carbon push rod,

with CA glue. Attach the piano wire a 20mm overlap to the carbon

rod. Use a generous blob of CA glue to coat this area. Slide the

heatshrink tube over and shrink using a heat source.

STEP

Installing the horns & pushrods.

SWITCH ON YOUR RADIO AND CANCEL ALL SUB TRIM

SET TRIMS TO NEUTRAL

Screw the screws into the horns so that the points of the

screws are just proud, Line up the horns as shown in FIG

5C, press down the horns, then screw them right down, get

the bottom part of the horn, align screws and screw down

until the horns grip the elevon, but not too tight.

Screw the clevises onto the pushrods halfway, attach the

clevis to the servo horn, Set the elevon position slightly

upwards as shown, mark the pushrod with a felt tip and

make your z-bend at this point. Note the horn holes may

need to be enlarged slightly,

Heatshrink

30mm

Use a ruler to set neutral position

Attach wing tips with glue

Wire

CA Glue

40mm