Asus CUW-AM Podręcznik - Strona 19

Przeglądaj online lub pobierz pdf Podręcznik dla Płyta główna Asus CUW-AM. Asus CUW-AM 21 stron.

2. HARDWARE SETUP

23) IDE Activity LED (2-pin HDLED)

This connector supplies power to the cabinet's IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE connector

will cause the LED to light up.

24) ATX Power Switch Lead (2-pin PWR)

The system power is controlled by a momentary switch connected to this lead.

Pressing the button once will switch the system between ON and SOFT OFF.

Pushing the switch while in the ON mode for more than 4 seconds will turn the

system off. The system power LED shows the status of the system's power.

25) ATX Power Supply Connector (20-pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup-

ply will only insert in one orientation because of the different hole sizes. Find the

proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT:

Make sure that your ATX power supply can supply at least 10mA

on the +5-volt standby lead (+5VSB). You may experience difficulty in power-

ing ON your system if your power supply cannot support the load. For Wake-

On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

0 1

CUW-AM

CUW-AM ATX Power Connector

+12.0 Volts

+5V Standby

Power Good

Ground

+5.0 Volts

Ground

+5.0 Volts

Ground

+3.3 Volts

CUW-AM User's Manual

+5.0 Volts

-5.0 Volts

Ground

Power Supply On

Ground

-12.0 Volts

+3.3 Volts