Carl's Place Pro Enclosure Kit Instrukcja montażu i instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja montażu i instrukcja obsługi dla Obudowa Carl's Place Pro Enclosure Kit. Carl's Place Pro Enclosure Kit 20 stron.
Również dla Carl's Place Pro Enclosure Kit: Instrukcja montażu i instrukcja obsługi (17 strony), Instrukcja montażu i instrukcja obsługi (20 strony)

Drukuj stronę
Secure each of the bottom
grommets of the screen
with a zip tie. Wrap the zip
tie under and around the
bottom pipe, held in place
by the exposed receiver
end.
These 2 bottom zip ties can
be pulled tight.
Add zip ties to the remaining
grommets, tightening only
enough to maintain an even
gap between the screen and
the pipe.
Check the spacing. The bottom of the screen should be level with the floor.
Screen lifting off the floor? Adjust
zip ties to obtain minimal gap on
the floor. Don't forget the sides,
you may have too much tension
on one of the zip ties attached to
the vertical pipes.
If the screen rests on high pile carpet,
you might find an increased number of
golf balls making their way under the
screen. To keep the balls from rolling
away, consider adding a back cover.
Page | 18