AND UA-705 Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor ciśnienia krwi AND UA-705. AND UA-705 15 stron.
Drukuj stronęIf a subsequent measurement is required, turn off the power and turn it on again.
When "0 " is displayed, the device is ready for another measurement.
Note: Allow at least three minutes between measurements on the same person.
9. Automatic power-off function
If the device is left on after a measurement, it will turn off automatically after about one
minute. It may be turned off at any time by pressing the
button.
Notes For Proper Measurement
Sit down in a comfortable position. Place the arm to be used for the measurement
on a table or other support so that the center of the cuff will be at the same height
as your heart.
Relax for about five or ten minutes before taking a measurement. If you are
excited or depressed by emotional stress, the measurement will reflect this stress
as a higher (or lower) than normal blood pressure reading and the pulse reading
will usually be faster than normal.
Your blood pressure varies constantly, depending on what you are doing and
what you have eaten. What you drink can have a very strong and rapid effect on
your blood pressure.
This device bases its measurements on the heartbeat. If you have a very weak or
irregular heartbeat, the device may have difficulty determining your blood
pressure.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. Refer to page 4 for the descriptions of
the symbols.
This blood pressure device is intended for use by adults only. Consult with your
physician before using this device on a child. A child should not use this device
unattended.
Measurement with storing data ( Refer to page 8)
Press the
START
device. The device can store the last thirty sets of data for each button.
Recalling data
Press and hold the
Stored data are automatically displayed in order from
the last data.
Clearing data
Remove battery to clear all data. Re-install it again.
Operation Mode
button. Blood pressure is measured and data is stored within the
button to recall the data.
START
English 9
START
Press and hold
Data number
Alternation
Stored Data