Dremel DigiLab 3D45 Instrukcja serwisowa - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Drukarki 3D Dremel DigiLab 3D45. Dremel DigiLab 3D45 4 stron. Print removal
Również dla Dremel DigiLab 3D45: Skrócona instrukcja obsługi (2 strony), Instrukcje serwisowe (4 strony), Instrukcja obsługi (2 strony), Podręcznik (4 strony), Instrukcja kalibracji (2 strony), Skrócona instrukcja obsługi (2 strony)

Step 2: Remove Top Cover on the Extruder

a. Cut the filament just before the intake on the top of the

extruder.

b. Remove screw located on the right side hole using the

T10 Torx screwdriver. The first picture below shows the

location of the screw, the second picture a bottom view

of the area where the screw is located, circled in red,

is the screw that needs to be removed.

c. Unscrew the two screws on the top of the filament

guide bracket using the 2.5mm Hex wrench.

d. Remove the top cover.

SERVICE

e. Carefully unplug filament run out switch from the

extruder circuit board, ensuring to pull from the plastic

plug and not the wires; pulling the wires can damage

the connection to the extruder. Please see picture

below.

Step 3: Removing the Extruder Motor

a. Disconnect the white extruder terminal block from the

extruder connector as shown in the picture below.

Ensure to grab the block and avoid pinching the wires.

b. Unscrew the two motor screws below using the 2.5 mm

Allen key, as shown in the picture below. Please

ensure that the screws once fully unscrewed, should

still be left inserted in the extruder chassis hole.