Dromida Vista UAV Podręcznik - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik dla Quadcoptery Dromida Vista UAV. Dromida Vista UAV 6 stron.

FRONT

Color Blades,

Color LEDs

REAR

Black Blades,

White LEDs

NOTE: The rotor blades and each arm have arrows that indicate which way the

prop rotates. Please check the arrows to verify that the correct replacement

rotor blade has been installed.

GEAR SHAFT REPLACEMENT

1. Remove Rotor Blade from Gear Shaft

2. Push shaft down to remove it from the gear.

3. Install the new gear shaft and rotor blade if it is not damaged.

NOTE: While the gear is out, check it carefully for any cracks or damage

to the teeth.

MOTOR REPLACEMENT

1. Remove screw securing the

motor cover to the arm and

pull the cover off the motor.

2. Use a small flat blade

screwdriver to separate

the motor plug from the

socket. DO NOT pull the

wires.

3. Remove the motor from

the frame and insert the

replacement. Make sure

that the wire colors on the

replacement motor are the

same as the original. The

motors for the clockwise

props have black and

white wires. The counter-

clockwise props use motors with blue and red wires.

FLIGHT CONTROL BOARD REPLACEMENT

1. Remove all 4 motor covers and the two screws in the section between

the front and back arms.

2. Remove the battery frame.

3. Remove the LED covers and unplug all 4 motors. Carefully pull the motor

wires out of the frame.

4. Remove the two canopy screws and the canopy. Under the canopy is

canopy LED strip that must be unplugged from the control board.

5. Remove the 3 screws holding the control board and remove the board.

6. Install the canopy LED strip and the canopy. Be sure that the post is

supporting the back of the LED strip.