Dromida Vista UAV Podręcznik - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik dla Quadcoptery Dromida Vista UAV. Dromida Vista UAV 6 stron.
Drukuj stronę
7. Install the new control board and route the wires for motors. To prevent
damage to the wires, route them between the guides on the inside of
the arms.
8. Install the LED covers. Before tightening the screws, make sure the wires
are positioned so they will not be damaged.
9. Replace the motor covers.
10. Calibrate the quadcopter sensors.
TROUBLESHOOTING
PROBLEM: The quadcopter will not respond to the transmitter.
SOLUTION: (1) Turn off the transmitter and disconnect the battery for the
Vista. Re-link the quadcopter and the transmitter.
(2) Charge or change the battery on the quadcopter.
PROBLEM: Red controller LED is slowly fl ashing after linking.
SOLUTION: Replace AAA batteries.
PROBLEM: Unable to fl ip.
SOLUTION: Battery voltage is too low.
PROBLEM: Quadcopter is shaking.
SOLUTION: Check the props and the prop shafts for damage.
PROBLEM: The props spin but the quadcopter will not take off.
SOLUTION: Rotor blades are incorrectly installed. See the Rotor Blade
Replacement section.
90-DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE. Dromida will
repair or replace factory defects for 90 days from the date of purchase. This
warranty specifi cally does not cover crash damage, misuse or abuse. To make
a warranty claim, please contact our product support team at 1-217-398-
8970 option 6 or e-mail us at [email protected]. If requested
by Product Support, please send defective product to:
Hobby Services
3002 N Apollo Dr., Suite #1
Champaign, IL 61822
In the European Union, send it postpaid and insured to:
Service Abteilung Revell GmbH
Henschelstrasse 20-30
32257 Bünde Germany
E-mail: [email protected]
Please include a note about the problem, your contact information, and a
copy of the receipt.
This warranty applies only if the product is operated in compliance with the
instructions and warnings provided with each model. Dromida assumes no
liability except for the exclusive remedy or repair of parts as specifi ed above.
Dromida shall not be liable for consequential or incidental damages. Some
states do not allow the exclusion of consequential or incidental damages so
the above exclusion may not apply to you. This warranty gives you specifi c
legal rights and you may also have other rights which vary from state to state.
Tel: 01805-110111
(nur für Deutschland)
FCC REQUIREMENT
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR
TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY
TO OPERATE THE EQUIPMENT.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE COMPLIANCE INFORMATION
FOR THE EUROPEAN UNION
INSTRUCTIONS FOR DISPOSAL OF WASTE EQUIPMENT BY PRIVATE USERS
IN THE EUROPEAN UNION:
This symbol on the product or its packaging indicates this product
must not be disposed of with other household waste. Instead, it is
the user's responsibility to dispose of their waste equipment by
handing it over to a designated collection point for the recycling of
waste electrical and electronic equipment. The separate collection
and recycling of your waste equipment at the time of disposal will help to
conserve natural resources and ensure that it is recycled in a manner that
protects human health and the environment. For more information about
where you can drop off your waste equipment for recycling, please contact
your local city offi ce, your household waste disposal service or location
where you purchased the product.
DECLARATION OF CONFORMITY:
Product: Dromida 2.4GHz 4-Channel Tx Rx
Item number: DIDJ1105 MR100
Equipment class: 1
MR100 transmitter: The objects of the declaration described here are
in conformity with the requirements of the specifi cations listed below,
following the provisions of the European 2006/95/EC Low Voltage
Directive:
EN 60950-1:2006 Safety
FCC ID: IYFMR100