Daintree GE Current WFA100-SN Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Adapter Daintree GE Current WFA100-SN. Daintree GE Current WFA100-SN 11 stron. Wireless fixture adapter

Drukuj stronę

Daintree

Networked Wireless Fixture Adapter (WFA100-SN)

Installation Guide

Mounting

Figure 12: Mounting in ballast channel

The WFA100-SN is designed to be mounted inside a light fixture.

Typically, it is mounted in the ballast channel using two screws

A bar code label with the WFA100-SN's full IEEE address on it is

included with the WFA100-SN. This is the Fixture label. Affix this

label to the outside of the fixture.

Choose a standard location so that when someone looks for

fixtures containing an adapter, they will know where to look

for the IEEE address bar code label.

Figure 13: Mounting Template (observe measurements,

illustration may not be actual size).

Important Notices

Complete Installation Tests

Successful commissioning is dependent on testing each

wireless-adapted lighting fixture and control device at the time

of installation. Finding installation issues or device problems

earlier saves significant time during the commissioning process.

Record IEEE Addresses

If you have not already done so, be sure that each adapter's

IEEE address (last 4 or 5 digits) is recorded on the facility floor

plan. You can use the 4 or 5 digit Plan label supplied with the

adapter or you can write the last 4 or 5 digits on the floor plan.

This information will be used during the commissioning process.

After the system installation is complete, a marked-up copy of

the facility floor plan showing the identity and location of each

wireless adapter (including associated sensors) should be

available. This will simplify and expedite the commissioning

process.