3M Litmann Quality 3100 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt medyczny 3M Litmann Quality 3100. 3M Litmann Quality 3100 16 stron. Mining cable splice kit
Również dla 3M Litmann Quality 3100: Skrócona instrukcja obsługi (2 strony)
Drukuj stronę
3.0
Replace Insulation
3.1
Apply one half-wrapped layer of 3M
from edge of taper to edge of taper.
Note: Scotch
Glass Cloth Tape 27 or Scotch
®
included, may be added and used at this time.
3.2
Apply highly-stretched half-lapped layers of Scotch
Tape 130C (tacky side DOWN) over 1700P tape and up onto tapers. Build up
half-lapped layers of tape gradually going out on existing insulation ½" (13 mm)
past top of tapers. Tape should be wrapped to a thickness equal to or greater than
the original insulation.
past end of taper
3.3
Starting ½" (13 mm) past end of 130C tape apply one half-lapped layer of
1700P tape over the 130C tape, extending ½" (13 mm) past the other end of the
130C tape.
½" (13 mm)
past end of
previous layer
½" (13 mm)
Temflex
Vinyl Electrical Tape 1700P
™
™
Glass Cloth Tape 69, while not
®
3M
Temflex
™
Figure 5
Scotch
Linerless Rubber Splicing Tape 130C
®
Tacky Side DOWN
Figure 6
3M
Temflex
™
Figure 7
4
Electrical Vinyl Tape 1700P
™
Linerless Rubber Splicing
®
½" (13 mm)
past end of taper
½" (13 mm)
past end of
previous layer
Vinyl Electrical Tape 1700P
™
78-8127-6830-3-C