Auber WS Series Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler temperatury Auber WS Series. Auber WS Series 18 stron. Precision pid temperature controller

Drukuj stronę

• Plug the power cord to the power outlet on the wall.

• Turn on the controller to make sure the controller powers up properly. The

temperature display is in the range expected. Then, turn off the controller.

• Plug the heater to the back of the controller. If the heater has a switch, put it in the

off position. Put the sensor inside the container to be controlled.

• Turn on the controller.

• Turn on the heating device.

Remark The connector of sensor contains a slot for correct pin connection. It also has a

spring lock to prevent disconnect by accidental pulling on the cable. Following pictures

show how to install and remove it.

Fig 3a. How to install the sensor.