DuctSox U-Track Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Urządzenia przemysłowe DuctSox U-Track. DuctSox U-Track 16 stron.

Endcap

A U-track Endcap gives the U-track a nice finished look on cut ends. Endcap

is friction-fit and simply needs to be pressed into place. A sheet metal screw

should be used to hold the endcap in place.

Step 3 - 1 Row Style

Determine placement of track (both track path and elevation). The bottom

of the U-Track must be mounted 1.5" (38mm) for standard Glider and

Cord-In is 0.5" (13mm) above the

12:00 location of the DuctSox.

Track supports are spaced between

5 to 8 ft (1524 to 2440mm) apart

with a maximum of 8 ft (2440mm).

Additional Track Supports must

also be mounted at both ends of

continuous track runs for stabilization

(or as an alternative, the track can

be secured by mounting the ends

with threaded rod). The track support

cable will need to be mounted at

angles away from the sides of the track along with angled cables in-line with the track. See image above.

T's

There should be roughly 12" (305mm) from sidewall of DuctSox to the start of the branch track. Track too

close to the main run may cause premature failure due to abrasion from the track. Support around fabric

fittings may require additional track supports. NOTE: Offset distance of branch U-Track from main trunk is

approximately half of the main trunk diameter plus 12" (305mm).

12"

(305mm)

1.5" (38mm)

Standard

0.5" (13mm)

for Cord-In

12"

(305mm)

12"

(305mm)

Installation Guide: U-Track