Duplo DB-200 Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Bindownica Duplo DB-200. Duplo DB-200 18 stron. Perfect binder

Note that it's not necessary to drain the glue frequently if the machine is used constantly

under normal working conditions. However, in case the glue has been left unused for a long

period of time with the unit in the "ON" position, and the quality is found to be

unacceptable, use the glue replacement procedures or call your authorized dealer.

Maintenance

Cleaning Procedures

After you have finished using the binder for the day, follow the following steps:

1. Close the clamps while the LED display flashing "LOAD BOOK" or "LOAD PAD".

2. Press "START" and "CLEAR" keys simultaneously. The clamp station will automatically

move to the left of the machine and LED display "NP SVC".

3. Clean the residual glue that might be on the nipping plates and plate surfaces.

4. Press the "START" and "CLEAR" keys, the clamp station will return to its home position.

Open the clamps to the maximum position. Clean their surfaces and wax them.

5. Turn the DB-250 off.

To enter the timer setup menu, you will need to press and hold down both the "OPEN" and

"CLOSE" buttons, then turn the power on. You should see "SET TR" in the LED DISPLAY.

Press the "FUNCTION" button to sequentially display TR1, TR2, TR3, TR4, TR5, TR6,

"SAVE", "CANCEL", and "RESET". Once you have selected the setting to change, you need to

press the "OPEN" to increase the time and the "CLOSE" to decrease the time within their

ranges. Press "FUNCTION" button until you see "SAVE" in the LED DISPLAY. Then press the

"START" button to change it. Or select "CANCEL" and press "START" button to exit. To

return all settings to default, please use "RESET" followed by "START" button to recover the

factory settings.

WARNING: We only recommend you to change TR1.

Below are the default times for each TRx and it's description: