cayke back2backDESK Instrukcja instalacji - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie wnętrz cayke back2backDESK. cayke back2backDESK 20 stron.

OPERATION INFORMATION

PROGRAMMABLE HANDSWITCH OPERATION

(continued)

CHANGE THE HEIGHT UNIT OF MEASURE

(inches or centimeters)

The handswitch can display the table height in either centimeters or inches. With the help of the S5-menus,

the unit of measure can be changed.

To change the unit of measure, follow these steps:

1. Press and hold the 1, 2, and UP buttons until the display shows "S 5".

2. Confirm by pressing and releasing the "S" button. Now the display will have changed. The control box will

click twice indicating that the unit of measure was changed.

To exit the menu without making a selection, wait until the height display appears again.

CHANGE THE HEIGHT DISPLAY

If the displayed value does not match the actual height of the table top, the display can be corrected as follows:

1. Press and release the "S" button.

2. Press and hold the DOWN button until the display starts to flash.

3. Change the height shown on the handswitch by pressing the UP or DOWN button to the desired height.

Confirm by pressing and releasing the "S" button. The control box will click twice indicating that the unit of

measure was changed.

To exit the menu without making a selection, wait until the height display appears again.

1. Move the table up or down to the desired height.

2. Press the "S" button (in the display "S -" is shown.)

3. Select a position by pressing one of the four number buttons, 1-4, (if 1 is selected, the display will show the

setting as "S1").

4. The saved position is confirmed by a double click sound from the control box. The display shows the current

table height. Repeat steps to save a maximum of four different positions.

Press and hold the desired memory button (1, 2, 3 or 4) the table moves from the current position into the

saved position*. The button must be pressed until the position is reached. If the button is released, the table

will stop short of the desired height.

*unless the double click feature is programmed into the control box

16 |