Dynamite DYN4064 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka Dynamite DYN4064. Dynamite DYN4064 20 stron. Passport ultra ac/dc charger cycler

li-ion/Poly Balance Charge

warning Message

WARN

Volt Select Err

1. Set Wrong Battery Voltage

Balancer

No Connect

2. Balance Leads not Connected

Unbalance Volt

Over

3. Shows that the unbalanced voltage is above

the 10mV limit at 30mV. The charge will

automatically switch to a 100mA charge rate

until the battery cell voltages are balanced to

less than 10mV. The charger will begin normal

charging after the cells are balanced.

Cell Number 1

Volt Over 4.26V

4. Battery voltage is over 4.26V per cell.

See previous step. The charger will drop to a

low current rate until the cells are balanced

within specifications.

Dynamite Ultra AC/DC Charger/Cycler

See the status by turning the dial during

discharge.

30mV

1. Selected Discharge Voltage Cutoff

Discharge voltage is pre-set to 3.00V/cell and

the corresponding S count will be displayed

along side the voltage cutoff being selected.

Selecting the correct S count will automatically

set the appropriate voltage cutoff.

2. DC Input Voltage/System Temperature

li-ion/Poly Discharge Mode

Li-Poly Dischg

1.0A 12.0V(4S)

Message during li-ion/Poly Discharging

Li4S 0000:01 0001

DIS 1.00A 15.18V

Select Voltage

12.0V (4S)

Input

System Temp 36°C

13.01V