DYNANAV Dynaflow 2 Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy kontroli DYNANAV Dynaflow 2. DYNANAV Dynaflow 2 15 stron.

Drukuj stronę
MORE Button Options
1. Mode is to change the method of control for the DynaFlow such as whether I runs an Electric Motor
driven Valve or an Electric Motor driven Pump or even a Hydraulic Motor Driven Pump.
2. Units is where you can change whether the system is Metric or Imperial.
3. Max Speed is set the flow control for a Maximum Speed in which the flow control will not try to put out
more GPM or LPM.
4. Brightness is to control the brightness of the screen 1 to 10, 10 being the brightest.
5. Speed Mode has either Fixed Speed or GPS speed. Should the GPS signal fail, you can set this to
Fixed Speed to operate at for your nominal application speed. Other than that, the GPS signal will
adjust the flow to meet you Application Rate.
6. Fixed Speed is the nominal speed for your application.
7. Min. Speed is particularly useful for helicopters where the flow will not go lower than the Min. Speed. As
such the spray nozzles will still be putting out the correct spray pattern and droplet size.
8. App Version is where you can see the version of the application of the unit. You can periodically check
our website to see if there is an update that you can load onto a USB Data stick to UPDATE using this
button.
730 – 11731 BAYNES ROAD, PITT MEADOWS, BC, CANADA, V3Y 2B4
WEB PAGE:
www.dynanav.com
SIMPLE BY DESIGN – FLEXIBLE IN APPI\LICATION
4
PHONE: 604-465-0009
FAX: 604-465-0084