AFL IDEAA 144F Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa AFL IDEAA 144F. AFL IDEAA 144F 14 stron.

Drukuj stronę

CABLE INSTALLATION

1. Using a standard 216 style tool, or similar, remove the

shipping screws from each side of the swing down tray.

A total of two screws will be removed. (Figure 3)

2. Using a standard 216 style tool, or similar, loosen the

shipping screw from the swing down splice tray holder

in order to begin splicing. Do not remove this screw

from the swing down splice tray holder. (Figure 4)

3. Determine the appropriate compression fitting

for the application.

4. Located at the lower right side of the cabinet, knock

out the appropriate mounting hole to accommodate

the compression fitting. (Figure 5)

5. Install the compression fitting, reference the

Compression Fitting Installation section of this

document. (Figure 6)

6. Using local engineering practices determine which

fibers will be unused for the input splicing and separate

the bundles from the fibers that will be routed to the

splice tray.

7. Route the unused buffer tubes through the fiber

management rings located on the side wall of the IDC.

(Figure 7)

COMPRESSION FITTING

INSTALLATION

Caution: In order to avoid micro bends or fiber damage do not over-tighten the compression fitting

around the fiber cable.

1. Ensure that the mounting hole is free from burrs and that the cabinet surface is smooth and free of debris.

2. Place the hex portion on the body (not the sealing nut) into the mounting hole.

3. Insert the cable through the fitting to the desired position.

Note: For best practice, it is recommended that when working with the 9-port compression fitting that the

multi-port grommet be removed from the fitting body. Slit each of the application appropriate ports and align

the grommet around the cables. Once all required cables are seated in the grommet, insert both the cables

and grommet back into the fitting body.

4. Tighten the sealing nut to hand-tight.

5. Using a wrench hold the body hex stationary while tightening the sealing nut with a second wrench.

Tighten until the cable is held securely in place.

6. Check to ensure that the fitting body is still screwed tightly into the panel.

INSTALLATION INSTRUCTIONS

IDEAA

Shipping Screw

Figure 6

Interior Distribution Cabinet

Shipping Screws

Figure 3

Figure 4

Figure 5

Figure 7

Specifications are subject to change without notice.