AFL IDEAA 144F Instrukcja instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa AFL IDEAA 144F. AFL IDEAA 144F 14 stron.

3. Remove the top plate.

4. Determine the appropriate compression fitting

for the application.

5. Knock out the appropriate mounting hole

to accommodate the compression fitting.

6. Install the appropriate compression fitting.

Reference the Compression Fitting Installation

section of this document.

7. Using local engineering practices, determine the

port to be used on the MPO field for the MPO

distribution cable.

8. Use local accepted practices to clean the connector

end face and plug the connector into the appropriate

port. (Figure 11)

9. Use the fiber management rings to route the

MPO distribution cable through the back side of the

144F IDC. (Figure 12)

Note: A FUSEConnect

may be spliced onto a non-connectorized

distribution cable. The FUSEConnect

Splice-On Connector application will utilize the

same cable installation and routing techniques

outlined in steps 1-7. Reference the installation

instructions provided with the FUSEConnect

MPO Splice-On Connector. The document will

include the following:

•Fiber Preparation

•Fiber Splicing

•Connector Assembly

10. Use local accepted practices to label the MPO

distribution fiber connection in the appropriate space

on the door label, as applicable.

11. Repeat Steps 7 – 10 for each MPO distribution cable

to be installed.

MPO Splice-On Connector

MPO

INSTALLATION INSTRUCTIONS

IDEAA

Interior Distribution Cabinet

Figure 11

Distribution

Drop

Figure 12

Specifications are subject to change without notice.