AgSense AQUA-TRAC Lite Instrukcje dotyczące okablowania - Strona 15
Przeglądaj online lub pobierz pdf Instrukcje dotyczące okablowania dla Przyrządy pomiarowe AgSense AQUA-TRAC Lite. AgSense AQUA-TRAC Lite 20 stron. 2015-18 soil moisture monitoring
Drukuj stronęWiring the Acclima TDR315L Sensor
to the Aqua Trac Unit
Find the group of terminals (3) with the group label SDI.
1. Connect the Blue wire from the Probe to the terminal marked SDI as shown above.
2. Connect the White wire from the Probe to the terminal marked GND as shown above.
3. Connect the Red wire from the Probe to the terminal marked PWR as shown above.
4. Make sure the Sensor Power jumper on the board is set to 12v.
5. If multiple sensors are used, they must be pre-addressed starting at address 0,1,2,3 (max
of 4 sensors)
Page 12