HIKOKI CB12-ST2 Instrukcje obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcje obsługi dla Piła HIKOKI CB12-ST2. HIKOKI CB12-ST2 16 stron. Band saw stand

Drukuj stronę

English

(7) Check that the D6 knob bolt on the rear side is correctly

tightened, and that the main tool unit is securely

installed on the stand. (Fig. 5)

Front side

of the

band saw

Hinge (B)

2. Operating the switch

After installing the band saw on the stand, check that the

switch can be correctly operated.

(1) Check that the band saw stand is correctly secured, and

that the lever switch is in the OFF position. (Fig. 6)

Lever switch

(2) Install the battery on the main tool unit.

(3) Check that the band saw blade is not touching anything,

then turn the lever switch ON and OFF to check that the

band saw operates correctly.

NOTE

The lever switch does not function unless the switch is

held in the ON position using the switch holder.

3. Adjusting the lower limit position of the band saw

blade

Adjust the positions of the base of the band saw stand

and the tip of the band saw blade. (Fig. 7)

(1) Remove the stopper bolt and screw it several turns into

the screw hole for keeping the stopper bolt.

(2) Slowly move the main tool unit down, and adjust the

position of the guide plate so that the tip of the band saw

blade stops approximately 2 mm below the top surface

of the base. (Use the 4-mm hexagonal wrench supplied

as a standard accessory.)

(3) After ﬁ nishing the adjustment, ﬁ rmly secure the guide

plate using two M6 screws.

Rear side

of the

band saw

Fig. 5

OFF

Fig. 6

Band saw blade

Top surface of the base

4. Adjusting the perpendicularity of the band saw

blade

<Adjustment of the perpendicularity between vise (B) and

the band saw blade (Fig. 8)>

(1) Loosen the two vise (B) adjustment bolts using the 8-mm

hexagonal wrench supplied as a standard accessory.

Ensure that vise (A) is away from vise (B).

(2) Place the vise guide supplied as a standard accessory

as shown in the ﬁ gure. Move the main tool unit down to

lightly press the vise guide against the side of the band

saw blade and the guide plate.

(3) Lightly press the vise guide so that it does not move, and

place vise (B) so that it comes in contact with the vise

guide.

Tighten the two vise (B) adjustment bolts to ﬁ rmly secure

vise (B) in that position.

Vise (A)

Vise guide

Band saw blade

NOTE

If a higher level of cutting precision is required, adjust the

vise position using a speed square.

M6 screws

Guide plate

Stopper bolt

Fig. 7

Vise (B)

adjustment bolt

Vise (B)

Guide plate

Fig. 8