Brita 3-Way Water Filter Dispenser System Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkt hydrauliczny Brita 3-Way Water Filter Dispenser System. Brita 3-Way Water Filter Dispenser System 13 stron. 3-way water filter dispenser
Drukuj stronę
3.3
Step 3: Installing the BRITA 3-Way Water
Filter Dispenser
To install the BRITA 3-Way Water Filter Dispenser, fi rstly ensure
you have all the components required (see fi g. 5).
1. BRITA 3-Way Water Filter Dispenser (design may differ) with
3 hoses
2. Shank (WD 3010 different design)
3. Base (models WD 3030 and WD 3040 only)
4. Joint
5. Flat Gasket
6. Flange
7. Hex nut
Please make sure that there is enough room for the P 1000 fi lter
cartridge, the hoses and the BRITA electronic cartridge exchange
indicator under the sink.
(fi g. 5)
First of all, dismount your existing kitchen tap.
A a) Turn off the cold and hot water supplies
b) Please make sure you release any pressure by opening
all levers.
1.
2.
3.
4.
5.
6.
7.
!
No water should run through the existing kitchen tap!
c) Unscrew the existing hoses from the cold and hot water
supply.
We recommend placing a suitable container under the water
!
supply as there will be water left in the hoses which will run
down when you unscrew them!
d) Unscrew your kitchen tap – there is no standard mounting but
in general a pipe wrench will help you to dismount it.
e) Pull out both your kitchen tap and the hoses.
You're now ready to install the BRITA 3-Way Water Filter Dispenser
(see fi g. 5).
First of all, screw the shank (2) into the 3-Way Water Filter
Dispenser (1).
Screw the hoses into the dispenser (see fi g.6).
Screw the M8 connector of the hose with the blue stripe into the
hole H 1.
Screw the M8 connector of the hose with the red stripe into the
hole H 2.
Screw the M8 connector of the 800 mm hose into the hole H 3.
H1
H3
H2
(fi g. 6)
Ensure the connections are screwed tight, but avoid over
!
tightening!
Then put the base (3) over the hole and fi x the BRITA 3-Way Water
Filter Dispenser (1) in place using the supplied counter plate (4), the
gasket (5), the locking ring (6) and the hexagon nut (7).
3.4
Step 4: Attaching the hoses
We recommend that you arrange all the parts you need in
!
front of you before you begin.
5
ENGLISH