Brita 3-Way Water Filter Dispenser System Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkt hydrauliczny Brita 3-Way Water Filter Dispenser System. Brita 3-Way Water Filter Dispenser System 13 stron. 3-way water filter dispenser
Drukuj stronę
f) Connect the hose with the red stripe with your hot water supply.
If your hot water supply does not fi t the 3/8" connector, use the
supplied adapter if required. Please insert the 1/2" gasket into
the female nut of the adapter fi rst.
g) Make sure all connections are tightened properly. Avoid over
tightening.
The max. tightening torque for the G3/8" connections may
not exceed 14 Nm! Only hose connections with gaskets
!
(5) may be used – hoses with conical screw connections
damage the connections of the fi lter head and invalidate any
warranty claims!
3.5
Step 5: Inserting the fi lter cartridge (see fi g. 8)
A Remove the protective cap (1) and check if the O-Ring is
installed (see fi g. 8).
B Insert the fi lter cartridge (4) vertically into the fi lter head (2).
2.
3.
5.
1.
4.
(fi g. 8)
The fi lter cartridge can only be inserted when the locking
!
handle is open.
Make sure that the fi lter cartridge is positioned correctly.
C Turn the locking handle (3) until you feel it engages.
3.6
Step 6 (optional): Space-saving wall mount
to install the cartridge under the sink
(see fi g. 9)
During assembly, note the installation dimensions, bending
radii of the hoses and dimensions of the accessories. The
!
system can be operated vertically and horizontally. When
using the wall mount, install vertically only!
1.
2.
3.
4.
(fi g. 9)
7
ENGLISH