IKEA IHW7302YS0 Instrukcja obsługi i konserwacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Okap wentylacyjny IKEA IHW7302YS0. IKEA IHW7302YS0 44 stron. 30"(76.2cm) wall-mount canopy range hood

Drukuj stronę

For Non-Vented

(recirculating)

Installations

If it is not possible to vent cooking fumes and vapors to the

outside, the hood can be used in the non-vented (recirculating)

version, use the air deflector (supplied) and a charcoal filter kit

(not supplied). To order, see the "Assistance

or Service" section.

Roof Venting

Wall Venting

Non-vented

(recirculating)

A. Roof cap

A. Wall cap

A. Deflector

B. 6" (15.2 cm)

round vent

Calculating

Vent System Length

To calculate the length of the system you need, add the

equivalent feet (meters) for each vent piece used in the system.

Vent Piece

6" (15.2 cm) Round

45 ° elbow

2.5 ft

(0.8 m)

90 ° elbow

5.0 ft

(1.5 m)

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in

conformance

with National Electrical Code, ANSI/NFPA 70 (latest

edition), or CSA Standards C22.1-94, Canadian Electrical Code,

Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes

and ordinances.

If codes permit and a separate ground wire is used, it is

recommended

that a qualified electrician determine that the

ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch

Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

•

A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is

required.

•

If the house has aluminum wiring, follow the procedure

below:

1. Connect a section of solid copper wire to the pigtail

leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors

and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's

recommended

procedure. Aluminum/copper

connection must conform with

local codes and industry accepted wiring practices.

Wire sizes and connections must conform with the rating of

the appliance as specified on the model/serial

rating plate.

The model/serial plate is located behind the filter on the rear

wall of the range hood.

Wire sizes must conform to the requirements of the National

Electrical Code, ANSI/NFPA 70 (latest edition), or CSA

Standards C22.1-94,

Canadian Electrical Code, Part 1 and

C22.2 No. 0-M91 (latest edition) and all local codes and

ordinances.

Maximum equivalent vent length is 35 ft (10.7 m).

Example

vent system

90° elbow

6 ft (1.8 rn)_

Wall cap

The following example

falls within the maximum

recommended

vent length of 35 ft (10.7 m).

1 - 90 ° elbow

= 5.0 ft (1.5 m)

1 - wall cap

= 0.0 ft (0.0 m)

8 ft (2.4 m) straight

= 8.0 ft (2.4 m)

Length of system

= 13.0 ft (3.9 m)