CORNING SCF-1728 Podręcznik - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt laboratoryjny CORNING SCF-1728. CORNING SCF-1728 14 stron. Heat shrink open ribbon system (hs-ors) canister splice closure

Drukuj stronę

One express (mid-span) cable may be placed in the express port or up to two individual cables may be installed

using the supplied three-finger clip.

Step 1:

Place a wrap of tape around the cable sheath at the distance specified in Figure 2. Remove indicated

length of cable sheath and armor (where applicable) according to cable manufacturer's instructions.

Cable Sheath

TPA-6300

IMPORTANT:

Do not expose the bare fibers until after the cable has been placed in the closure end cap. Do not

untwist the subunits or remove their jacketing.

Step 2:

Pull the outer jacket open to the tape mark (Figure 3). Ring cut about halfway through the GRP rods

and polyethelene jacket. Bend the jacket back.

Step 3:

After jacket is bent back, cut off the jacket and GRP rods (Figure 4). Then remove water-swellable tape

with scissors.

TPA-5939

15 feet of exposed ribbon subunits

TPA-5940

Figure 3

Standard Recommended Procedure 206-455-AEN | Issue 1 | November 2018 | Page 3 of 14

Figure 2

GRP rods

Water-swellable

tape

Figure 4